Re: Polish aluminum engine

Posted by D-train On 2014/1/15 17:34:19

If you blast anything, remember to seal all orafices/entries into the engine well. ...as blasting leaves media in places that you didn't think that were accessible.

...and when it comes time to remove said coverings, watch that loose media isn't present on the covering. It can then fall into the orafices on removal.

I rebuilt my fuel pump last summer and found glass beads in the fuel pump vent line. The filtering element stopped it from entering the crankcase, but I was surprised as heck to see it there.

Good luck,

Mark