Re: 1940 Super Clutch and Rear Crank Seal

Posted by todd landis On 2014/10/21 17:38:27

Finished the new clutch, after a few times out, very smooth. One thing I just noticed. The tail end of the overdrive is off to one side just a bit maybe 1/4 inch. Probably does not make a difference, except where it is attached to the rear rubberized coil, causing it to tilt off center just a bit. What might cause this? The rear mounts look exactly the same, right or left. Is there a bit of side to side adjustment on these rear mounts? I don't think so, but could be wrong.
Thanks