Re: Connecting Oil Pressure Line

Posted by Owen_Dyneto On 2014/9/11 23:00:13

If I didn't have a screw driver that fit the full width and depth of the slot, I'd grind a square-shanked one to fit, insert it and give the end a couple of raps with a light hammer. Then while putting as much pressure as you can on the end of the screw driver to maintain full contact in the slot, turn the shank of the screw driver with a wrench.

You might also consider using a Dremel to square up and deepen the slot. I doubt PB Blaster will accomplish much, little if any serious corrosion is going to occur between the cast iron and brass.