Re: Valve grinding tools

Posted by Ken_P On 2014/10/28 20:59:38

I found a local machine shop here, I'll call tomorrow to get a price and go from there.

Thanks for all of the information! I will have the three angle valve job done at the same time- no reason to hand lap if I have to get new valve seats.

Not too bad to pull the engine- I already have the entire front clip off. I will have to buy, borrow, or rent a cherry picker. I was planning on buying one some time, just not tomorrow. The small silver lining is that it will make the touchup painting on the block I need to do that much easier.

I'll update once I have the machine work done.