Re: FRONT WHEEL BEARING AND NUTS ON A '32 901
Posted by Marty or Marston On 2015/11/5 11:14:40
I want to thank to everyone for responding and especially Dave for his great write up and explanation. It was pretty much what I thought, but I wasn't sure about the purpose of the hole in the outer nut and wanted to make sure that I didn't miss something.
I repaired the tab on the washer. When I put everything back together I bent the ends of the cotter pin inwards to minimize the amount of travel the out nut could back off if it loosen up. Maybe all the nuts were all made with holes and then pins were inserted on those that were on the inside.
Attach file:
(29.72 KB)
(54.29 KB)
I repaired the tab on the washer. When I put everything back together I bent the ends of the cotter pin inwards to minimize the amount of travel the out nut could back off if it loosen up. Maybe all the nuts were all made with holes and then pins were inserted on those that were on the inside.
Attach file:
(29.72 KB) (54.29 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=168638