Re: Front wheel bearing lock nuts 37- 115 c

Posted by David rose On 2016/1/4 9:18:38

Good morning, Yes you can damage the tab, so this is what I did, I used 1/8" x 1 1:2" flat steel stock and cut pieces to the shape of a wrench using the 1 5/8" nut as a guide I clamped the pieces to my welding table. After fabricating it was still to wide to fit I back of the lock washer so I tapered the wrenches outside edges to fit behind the locking washer because the space was less than 1/8". Also every time I locked the nuts together using the wrench the bearings were to tight so I had to back it off another hole in the locking ring. Dave