Re: 1940 110 4dr king pins

Posted by flackmaster On 2016/3/28 12:42:38

I must also add that West's writeup and photos illustrate what is great about this site - not only had West done this in the past, but stepped up to direct the poster to the specific point at his blog. Kudos to West.

And just some minor points of interest - depending on the king pin kit selected, NOS, aftermarket or Reproduction, there may be bushings to ream, or needle bearings which are a specific fit. Be sure to coordinate the location of the grease fitting to the corresponding holes in bushings or bearings. Finally, I have come across worn wheel supports which act like worn king pins, so be sure to check this too.

DAF