1928 526 Drum headlights
Posted by rrhorton On 2016/11/1 20:54:23
Received my cans and rings back from the plater and have the fitting and new bolt ready to attach. I have obtained two reflectors but the one shown seems to be the one that fits my cans. It has two tabs at 3 and 9 o'clock that look like the fit into each other to align the reflector. My reflectors have two lamp sockets. I know the center one is a two filament bulb for high and low beams. Is the other for parking light bulb? Does it go at 12 or 6 o'clock? Or does the 526 not have two lamp sockets?
I also had Olson's gaskets make me a couple of cork strips to place around the reflector to make the lens tight when the ring is attached. Can anyone tell me how to assemble the light correctly. Are there any lens clips, what are the hole and slot in the reflector at 6 and 12 o'clock for?
Where can I get the adjustment assy that fits on the inside of the can? Right now I am planning to fill the holes with chrome machine screws and use new fixed bulb sockets in the reflectors.
Attach file:
(46.49 KB)
(52.85 KB)
(37.67 KB)
I also had Olson's gaskets make me a couple of cork strips to place around the reflector to make the lens tight when the ring is attached. Can anyone tell me how to assemble the light correctly. Are there any lens clips, what are the hole and slot in the reflector at 6 and 12 o'clock for?
Where can I get the adjustment assy that fits on the inside of the can? Right now I am planning to fill the holes with chrome machine screws and use new fixed bulb sockets in the reflectors.
Attach file:
(46.49 KB)
(52.85 KB)
(37.67 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=183981