1941 180 Clutch and Throwout Bearing Questions
Posted by hynesjm On 2017/6/11 13:32:14
Hey Guys, first post here and I am looking for some information. the Car is a 1941 Packard 180 with a super 8 and aerodrive (overdrive) 3+1 transmission. Thanks in Advance!
First Question;
I am installing the trans back to the engine, and I can't seem to figure out where the little spring on the throwout bearing is supposed to attach to. Am I missing a piece? See the circled spring in the TOB_return_spring.png and the input_shaft.jpeg in the attached pictures.
Second Question;
I ordered a new throwout bearing from Kanter, and I am questing whether what I received is the correct one. Also, if it is correct, how do I install it? is it just press-off the old one and press-in the new one (see attached pictures)?
Attach file:
(178.90 KB)
(224.74 KB)
(268.12 KB)
(187.11 KB)
(178.56 KB)
First Question;
I am installing the trans back to the engine, and I can't seem to figure out where the little spring on the throwout bearing is supposed to attach to. Am I missing a piece? See the circled spring in the TOB_return_spring.png and the input_shaft.jpeg in the attached pictures.
Second Question;
I ordered a new throwout bearing from Kanter, and I am questing whether what I received is the correct one. Also, if it is correct, how do I install it? is it just press-off the old one and press-in the new one (see attached pictures)?
Attach file:
(178.90 KB) (224.74 KB)
(268.12 KB)
(187.11 KB)
(178.56 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=192883