Re: 1941 180 Clutch and Throwout Bearing Questions

Posted by fredkanter On 2017/6/11 14:30:14

The best place to get accurate information about the correctness of a part is from the company that sold it to you. Posting if something was correctly supplied befroe asking the seller puts a question in the minds of other forum members and certainly does not help the reputation of the seller. Throwout bearings have ID's down to the .001 of an inch, nobody seeing your photos can see the dimension.

Yes you press off the old one and press on the new one.

Look on the front bearibng cover of the trans (held on by 5 or 6 bolts) and you will seee a little loop, that's where the spring atttaches. when you removed the trans you had to take the spring off that loop