Re: 1941 180 Clutch and Throwout Bearing Questions

Posted by hynesjm On 2017/6/11 17:30:11

Guscha and HH56;

Thanks for the picture and description of the 3/16 clevis pin - that is the arrangement that I have, with the small hole to the passenger side of the vehicle in the bellhousing. Looks Like I'll have to source a 3/16" Clevis pin as it seems to have been lost.

fredkanter,

It was not my intent to cast doubt about Kanter's parts. What I should have said was something to the effect of "This part looks a little bit different from what I have, do the new replacement parts look a little bit different from what I am replacing like these pictures show?"

Also, again my fault for not being clear, but I got the car in pieces, so I did not actually take it apart. Hence my rather naive question.