Re: 1936 Packard 120 Trunk Rack and Trunk

Posted by 120p400 On 2008/12/23 20:59:03

Thanks Mal and Thomas, The photo of the trunk on the 36 is the right idea, but this trunk is simply belted to the rack (and you probably knew that.) The photo shows the two tapped holes in the trunk rack where an assembly would bolt and i believe these holes are only on the right side as shown. So the parts book is showing the correct picture. I now see the spread bumper guards (which is correct for factory rack on 36 120) will not allow the trunk to tilt far enough over.
Thanks to all for any help on this.
Craig

Attach file:

---

  (41.54 KB)