Re: Solenoid Base Plunger Seal
Posted by HH56 On 2018/5/25 13:37:41
That is correct. In the old thread I linked above, on page two, post 12, about halfway thru the photos in that post Joe shows removing the washer and seal. The washer may be staked but should come out without too much grief.
Here is an illustration of how a typical lip seal should be oriented with the lip toward the side where pressure or liquid originates. Illustration is of a PS seal install but the OD seal installs the same way and direction but is without the extra pieces. Instead of toward cylinder the inner lip would face toward OD.
Attach file:
(33.37 KB)
Here is an illustration of how a typical lip seal should be oriented with the lip toward the side where pressure or liquid originates. Illustration is of a PS seal install but the OD seal installs the same way and direction but is without the extra pieces. Instead of toward cylinder the inner lip would face toward OD.
Attach file:
(33.37 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=203096