Re: Solenoid Base Plunger Seal

Posted by todd landis On 2018/5/26 7:07:03

Good. Just make sure you have not rotated the drive shaft. If so the pawl cannot pull all the way in. If you make or have a small hook you can tell if the pawl goes in the full way or not. In my case my little finger can put pressure on the pawl through the round hole. Put the pressure on it rotate shaft and you will feel when pawl goes into place. But you will need a hook or in my case made a rod with a small ball on end to pull the pawl all the way outwards where it needs to be to engage solenoid ball shaft without being energized.