Re: Gas gauge removal

Posted by Packard Newbie On 2018/11/19 2:07:11

Hi 'Dumper',

I have a '39 4-DR sedan and can only speak to THAT fuel gauge, but presuming they are similar, the unit isn't that hard to remove. One disconnects the wires from the gas gauge and ammeter (careful, as the ammeter wire is hot regardless of the ignition switch being on or off) and then there are 4 studs on the back of the dash to which the gauge cluster is attached. Mine were secured with 1/4" nuts and a hand, nut-wrench seemed to be the easiest thing to use; the 2 on the outside of the cluster body must come right off and the two closest to the speedometer need only be loosened as they 'share' a common stud with the speedometer body and once loose the unit will come right out. The tin back has pressed 'latch-catches' and these can be gently pried apart with a flat screwdriver. After that, it is a simple procedure to remove and replace the gas gauge register. Also, check and make sure the sender unit is grounded to positive as that was the problem with mine - somebody had had it apart and put it back together negative ground. Hope this is of some help, good luck. Chris