Re: Frankford plating

Posted by Gary Kulp On 2019/2/11 10:26:27

About 6 years ago I had Grill bars and top and bottom parts done there. The back of the center bar looked as if will rust. All the bars were notched with a cut off wheel leaving some with about off 1/4 inch of the tab left. Why didn't they drill them with a very small hole, to hang them with the wire for plating? It is my understanding that it is now run by the son of the original platter, who does mostly commercial plating. Very detailed parts are sent to another phily platter to finish.

I would use Librandi's Plating 717-944-9442 in Harrisburg,Pa. very close to the air port complex. I had my conv.windshield frame done there and had one spot one the back of the vertical post that looked as it might lift later,so I took it back and there was no argument,they just redid it and sent it to me no extra charge.