Re: Packing rear axle bearings on a 39

Posted by HH56 On 2019/2/18 19:55:03
On the key, any chance of tapping the point of an awl above the threads right at the end of the key where the bottom mating surface is flush with the shaft and then getting some kind of wedge action going to get the key end raised a bit. You might need to touch up where the awl point will undoubtedly gouge a bit but shouldn't be too much damage.

This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=209456