Re: Packing rear axle bearings on a 39

Posted by Owen_Dyneto On 2019/2/18 19:58:36
Bearing is pressed on using very considerable force (multi-ton hydraulic press). If the new one is also going to be loose (don't just assume so) I'd stipple the shaft where the bearing will sit, additional use of Locktite couldn't hurt.

I've had good luck removing stuck keys by inserting a very thin jeweler's screwdriver between the slot and the bottom of the key and tapping with a light hammer.

This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=209457