Re: Packing rear axle bearings on a 39

Posted by jfrom@kanter On 2019/3/1 13:43:51

Our brake hardware kits are based off an industry standard. Meaning the kit contains the hardware that is most likely to fail do you excessive heat and movement. The anti rattle springs that go over the parking brake bar from an industry standard not considered a wear item and is not a standard part in a brake hardware kit. Pertaining to the problem with the hold down pins/nails that you received. Can you tell me what is the number stamped into the end of pins that came in the kit? It is normally either a one or two digit number? Also what was the number on your original pins?

We would like to resolve your issue.

Thanks
James From
Kanter Auto Products