Re: Broken Starter Motor ends

Posted by HH56 On 2019/2/13 10:28:54

Or going a bit more with Mal's thought, what about a foundry that does small job sand casting and finish up with lathe work as needed.

There are a few foundries here who advertise in Hemmings and other magazines offering the service of simple sand castings of one or two piece runs in steel or other metals for old car parts. Not sure how much the large openings would complicate things but would expect Oz to have some foundries as well but maybe concentrating more on farming or station needs than the cars.

It would take an original end plate maybe glued together with a bit added to allow for casting shrinkage and maybe some work to figure out the openings to make a center core for the pattern but if all the pieces are present that would probably be a minor detail for a good foundry.