Re: Coil Spring Installation
Posted by SteveP516 On 2019/3/16 16:02:51
Gentlemen,
Thank you for the input...........James, I will try your suggestion first. I have a 37 manual, so I'm going to take a look at the instructions.
I'm somewhat concerned, because the spring has to be compressed at least 3" to fit into the perch. I just don't think I can get that amount by loosening the hardware, but I'
m going to give it a try tomorrow.
Howard, Thank you for the suggestion.
As a side note, I was able to get the rear springs and rearend installed today. So, I did make progress!
Regards,
Attach file:
(256.63 KB)
Thank you for the input...........James, I will try your suggestion first. I have a 37 manual, so I'm going to take a look at the instructions.
I'm somewhat concerned, because the spring has to be compressed at least 3" to fit into the perch. I just don't think I can get that amount by loosening the hardware, but I'
m going to give it a try tomorrow.
Howard, Thank you for the suggestion.
As a side note, I was able to get the rear springs and rearend installed today. So, I did make progress!
Regards,
Attach file:
(256.63 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=210227