Re: '38 six cyl question

Posted by toymanbob On 2019/6/26 20:04:50

New update. Kanter returned the correct bearings but when my machinest read the instructions and determined that he would need to hone about fifteen thousandths from the rod big end diameter he was not happy. He is looking for someone to bore it out. I appreciate the offer of the correct bearings but I'm not sure yet how to proceed . And, I tried to order head studs and was told there is a six week backlog! This is a very frustrating engine build, Bob

Attach file:

---

  (356.07 KB)