Re: '38 six cyl question

Posted by toymanbob On 2019/7/3 16:57:08
Thanks to Kanter for stepping up and sending new seals without being asked. Bravo! Now I have to go back to them begging as I hope to return the '39 bearings as I have found the proper bearings, thanks to Flackmaster. It's a good thing as the only shop in southern Oregon wanted $200 and six weeks to mill them And then, I would have had to pay another $75 to get them honed to size. For the second time! When I said shrink to fit earlier I just meant that the material being shaved off the side seals as I was installing the rear cap was probably sizing the seals to a perfect fit. Until it broke. And the gasket set is labeled Best Gasket. Bob

This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=213074