Flywheel and pressure plate
Posted by jwblazek On 2019/10/26 12:10:51
Just got the flywheel and pressure plate back from the shop. Those of you near San Jose Ca, FleetPride ( formerly BnA friction I think)did an utterly fantastic job on the pressure plate, looks better than new
Looking at the flywheel, I see the mounting holes for the pressure plate are counterbored, why? Bolts, as I recall, were not shoulder bolts
Question today is the torque specs. What torque for the flywheel to crankshaft and what torque settings for the pressure plate to flywheel bolts?
And don't recall seeing lockwashers on bolts holding pressure plate on. Same with flywheel to crank, although these are shoulder bolts. I think they should have them, replacing with all new grade 8 stuff
Thanks
John
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=216158