Re: dashlights dimmer switch
Posted by HH56 On 2019/11/14 11:05:33
After seeing the second set of photos I am reasonably confident the terminals are identified correctly on the switch. The question now is whether there is corrosion causing the problem or a broken wire. I am leaning toward corrosion as I suspect the wire from the end of the rheostat goes thru the ceramic and wraps around the rivet on the front side where the green blotch is seen. Never having examined a switch up close I can only guess though. You might try cleaning the green area and see if it is corrosion or paint and if there is an end of the rheostat wire that is fastened under the terminal. If it is corrosion and has gotten under the rivet and terminal that could be a significant issue.
Another question would be which is the actual contact for the reading light. There is a small straight line which could just function as the locating tab which keeps the terminal from rotating on the ceramic or it could be that the same wiper that contacts the rheostat wire continues on to touch the metal and make that connection when the reading light is desired. The large round head of the rivet could also be the connection if the large portion of the wiper is also electrically active rather than just there to provide protection and tension for the actual wiper. It could be that both points are used due to the extra current needed for the reading lights. Without seeing the switch can not tell how the center connections to the power in terminal is made as to whether just the wiper is connecting or are both pieces together.
The reading light I am referring to would appear to be one or two lamp assys mounted directly under the edge of dash if this 39 six factory diagram is accurate. No idea if those were standard or optional so they might not be on your car or maybe was removed or connected in another way at some point.
I sort of suspect your switch wiper gets power similar to the later switches where the wiper rotates and a small protrusion on the wiper rides against the solid metal plate connected to the power in terminal. The solid plate on later switches corrodes or oxidizes and the extra resistance as the wiper tries to make contact is enough to lower voltage to the dash lights as if there was another section of resistance wire. That hard to access area is where Ross places the valve grinding compound and I would suggest you also examine that area on yours to see if it appears oxidized.
Attach file:
(108.39 KB)
(111.39 KB)
(89.79 KB)
(18.66 KB)
Another question would be which is the actual contact for the reading light. There is a small straight line which could just function as the locating tab which keeps the terminal from rotating on the ceramic or it could be that the same wiper that contacts the rheostat wire continues on to touch the metal and make that connection when the reading light is desired. The large round head of the rivet could also be the connection if the large portion of the wiper is also electrically active rather than just there to provide protection and tension for the actual wiper. It could be that both points are used due to the extra current needed for the reading lights. Without seeing the switch can not tell how the center connections to the power in terminal is made as to whether just the wiper is connecting or are both pieces together.
The reading light I am referring to would appear to be one or two lamp assys mounted directly under the edge of dash if this 39 six factory diagram is accurate. No idea if those were standard or optional so they might not be on your car or maybe was removed or connected in another way at some point.
I sort of suspect your switch wiper gets power similar to the later switches where the wiper rotates and a small protrusion on the wiper rides against the solid metal plate connected to the power in terminal. The solid plate on later switches corrodes or oxidizes and the extra resistance as the wiper tries to make contact is enough to lower voltage to the dash lights as if there was another section of resistance wire. That hard to access area is where Ross places the valve grinding compound and I would suggest you also examine that area on yours to see if it appears oxidized.
Attach file:
(108.39 KB)
(111.39 KB)
(89.79 KB) (18.66 KB)This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=216759