'37 120C Steering Wheel installation

Posted by R Howe On 2019/11/27 11:09:27

Hello, again. Does anyone have any information on removing the hex shaped splined nut on the steering column so that the steering wheel might be installed? I cannot see where this piece slides out and over the threaded portion of the shaft. The way it appears to me is that this splined nut goes in after the steering wheel has been set onto the splines and forced into place. The second nut then goes onto the shaft after the splined nut goes on and is there to hold everything in place. However, the puller I have is not budging the splined nut. Does anyone have any "tricks of the trade" to get this off, or is my analysis of the situation incorrect?/
Again, thanks to all for any information you might be able to provide.