Re: 37 Light switch removal

Posted by Packard Newbie On 2020/4/6 0:33:00
Again, not sure if the '37 is same or similar to the '39, but I made a very simple 'wrench' to undo the nut. It took 10 minutes and I can post a pic if it would be of any help. It is basically a piece of steel stock 5/8" wide with a 90 degree bend, about 1/2" long on the end. It's then cut away in the middle to go over the shaft of the light switch and the two little 'fingers' that are left ground down to fit the slots in the bezel. Works perfectly. Chris.

This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=220928