Re: 37 Light switch removal

Posted by Packard Newbie On 2020/4/6 12:05:22

Joe,

That one works for the switches where the knobs pull off, but with the light switch, where the knob is permanently affixed to the shaft, one needs something that can address the bezel nut at 90 degrees, thus the Flackmaster saying needle-nose with 90 degree ends CAN work. The tips can be a little too big though and rather than grind down a good set of pliers, my little doo-dad was easy to make and fits the slots. I will post a pic later today - I have to go out to the garage and round it up. Chris.