Re: 1937 "120" Running Board Rubber Installation

Posted by 37Blanche On 2024/4/10 13:48:43

Resurrecting this thread. I wish i researched more before i purchased the Running Board pads from Steele.

So it sounds like I need to basically make the running boards a flat surface to ensure good adhesion with the Pads.

Based on previous experience:
1. What is the best adhesive to use.
2. What was the best way to make the running boards "flat" (filling in ridges)
3. Any other tips or tricks folks can share!

Thanks in advance!
Ben