Re: clips for the belt line on our 1940
Posted by todd landis On 2020/10/31 11:47:28
See if this picture attaches. New computer and don't have the photo resizer installed, someone give me the link if needed?
Think I ended up using the 807, have to use a bench grinder to make the surface or top portion of round head a bit thinner. The legs are longer than original but will not be seen from outside. I am pretty sure used the 807 for luggage rack molding. The ones for the body may have used one of the other two, again may need to make the portion that goes into the molding a bit thinner cannot fully remember. Thanks
Attach file:
(134.67 KB)
Think I ended up using the 807, have to use a bench grinder to make the surface or top portion of round head a bit thinner. The legs are longer than original but will not be seen from outside. I am pretty sure used the 807 for luggage rack molding. The ones for the body may have used one of the other two, again may need to make the portion that goes into the molding a bit thinner cannot fully remember. Thanks
Attach file:
(134.67 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=227641