Re: Need shift linkage help

Posted by 58survivor On 2022/9/1 11:58:52

Thanks all for the quick replies and suggestions. This ended up being a simple fix by just using the alignment holes as suggested so I didn't need to disconnect the clevis pins again. Shifts just fine now - road test later but I don't expect any problems. I'll try to attach some pictures as the service letters don't make it clear where the alignment holes are.

I don't post much here but I do read this forum every night. The members here with their combined knowledge and willingness to help are among the best I've seen anywhere. Thank you all for your insights.

Attach file:

---

  1940 Packard Shift Linkage Alignment Holes.jpg (141.53 KB)


  1940 Packard Shift Linkage Alignment Holes 2.jpg (111.95 KB)