Re: PRE-ORDER (If there
Posted by HH56 On 2023/3/6 13:46:43
I don't know when the slots in the headlight bezel to assist in removal started appearing but perhaps a couple of slots located next to the shaft could be incorporated in the repro bezels and a tool could also be made available.
Chris made his own tool to remove his headlight sw bezel and Packard had various tool versions to accommodate the different spacing of bezel slots that changed over the years or for different sw functions.
Here are a couple of different versions of tools which do essentially the same thing but are for different switches. Some slots were right next to the shaft and others were toward the outer diameters. Something like flat stock with a notch and bent over tangs sized to fit the bezel slot dimensions and locations should be easy enough to make.
Attach file:
tool1.jpg (62.98 KB)
tool2.jpg (98.11 KB)
Chris made his own tool to remove his headlight sw bezel and Packard had various tool versions to accommodate the different spacing of bezel slots that changed over the years or for different sw functions.
Here are a couple of different versions of tools which do essentially the same thing but are for different switches. Some slots were right next to the shaft and others were toward the outer diameters. Something like flat stock with a notch and bent over tangs sized to fit the bezel slot dimensions and locations should be easy enough to make.
Attach file:
tool1.jpg (62.98 KB)
tool2.jpg (98.11 KB)This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=254635