Re: PRE-ORDER (If there

Posted by BigKev On 2023/3/6 14:46:04

The rod/bezel/knob is assembled as a single composite part by the factory and it's a one-year-only part.

The problem is that the chrome part of the bezel is a very thin fragile shell over a thicker base which essentially gets mangled if the threaded shaft was over-tightened when installed initially or rusted in any way.

Because of the one-piece assembly, there is no way to replace just the bezel.

It's frankly a bad design that was changed in later years.

On my car, I was able to unthread it by hand. But even then it had roughed up in the past and it shows.