Reproduction Part Request

Posted by Bob J On 2023/3/7 13:26:00

It has been raised that there are items that need to be looked at for reproduction for our old Packards.
I am glad to create 3D files for any small part or assembly but I need an actual part to use to reverse engineer the product.
I have also learned that the model/year part number MUST be specified to remove any doubt as to its end use.
If you have samples you can PM me.
The process as you know is to create the model in 3D then forward to Crin at White Glove who gets it quoted and applies minimum quantities to a run before it can be made.
And NO, I cannot do large parts like body panels, this will be hardware type parts.
Thanks a lot
Bob J.