Re: Radiator Mounting Pads 37
Posted by KMcoldcars On 2023/5/25 22:59:15
I just finished putting my 1936 120 together. The pads go in indentations on the outside of the bottom of the black sheet metal piece that goes into the radiator shell/grille assembly. I believe they are just to keep the sheet metal from rattling against the outer part of the shell. 2 on each side.
If yours is like mine the way the assembly was installed was quite easy.
The heavy black piece with the sheet metal piece was set in place with the big bolt at the bottom center installed in the large heavy black piece. Then the radiator was installed. Then the outer shell with grille was put in position. All of the mounting bolts were not tightened so a lot of adjusting could be done.
Attach file:
DSC_8598 copy.jpg (257.33 KB)
If yours is like mine the way the assembly was installed was quite easy.
The heavy black piece with the sheet metal piece was set in place with the big bolt at the bottom center installed in the large heavy black piece. Then the radiator was installed. Then the outer shell with grille was put in position. All of the mounting bolts were not tightened so a lot of adjusting could be done.
Attach file:
DSC_8598 copy.jpg (257.33 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=257320