Re: Shift Fork Springs Packard 110
Posted by Joe On 2023/6/24 21:57:05
Quote:
Packard Don wrote:
Is it possible that a clip above the arms is missing, causing the pair to be slid too far up the shaft?
Retaining ring and washer are there. I may try a large spacer and shim above the lower retaining ring. I have to find an acceptable ring first. I can’t think of any problems a thick spacer would create. As long as I take up the space and create minimal clearance between the forks. Not sure if I’m missing something…
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=258507