Re: 1932 Center Hood Hinge Operation

Posted by GaryinSC On 2023/7/12 13:12:19

You should be able to remove the center rod by sliding the hood sections off. You could also pull the center rod out completely. You need to hold the hood sides at the same time so need two people. When you remove the center rod you could just sand it down with emery cloth or one of the sponge pads and reuse it. It is just plain steel. You could also use a block of wood and a hammer and drive it out. I doubt it is stuck too much. The stainless hinge is good quality and should not be stuck too bad. Mine came right out and required a little sanding to make it look like new. A light coat of grease is all that was needed to make it work easily.