Re: Cylinder Head torque

Posted by TxGoat On 2023/7/14 16:12:35

Thanks. The head is in place and shows no evidence of any problems, but I have a good torque wrench and I think it would be prudent to check it. I'll set the wrench at 55 and go over all the nuts in order, and if nothing moves I'll go to 60 ft lb and go over it again. The engine was painted some time in the past, and there is no evidence of any tool marks on the head nuts, so it hasn't likely been checked lately. The gasket appears to be a traditional sandwich type gasket.