Re: North East TEU 10868 distributor

Posted by Marty or Marston On 2024/2/4 19:33:09

Since no one has replied, I'm guessing there is no great answer. The two should just come apart.

Since you are going to replace the wires, here's what I would try. I'd cut all 9 wires to remove the top with the lower part of the cap. Turn it upside down and soak them in paint thinner (which should not hurt the Bakelite) overnight. Then gently try removing the cap from the body. You could softly tap it, but remember it is very brittle and it would not hurt to have a backup all lined up.

GOOD LUCK

Before doing the above try squirting a spray lubricant along the side of the screw on top and let it sit for several hours