Re: North East TEU 10868 distributor

Posted by Marty or Marston On 2024/2/6 16:39:15

True - I was talking about the upper portion of the cap. If it is the lower portion of the cap, then spray that area with a lubricant several times over several hours. With a single edge razor blade gently try to insert it between the metal and plastic portion working around the entire circumference. Try GENTLY TAPPING the razor blade. Probably best the remove the distributor.

On the off chance the plastic part(s) break, it may be repairable using PC7 (a 2 part epoxy that takes a day to cure). I used it to repair the top portion of one I had. I'm holding it as a backup for my current one. Wet both surfaces with the minimum of the mixed epoxy and clamp them together allowing the PC-7 to cure overnight.

GOOD LUCK