Re: install accelerator cross shaft retracting spring 1937 115
Posted by Bob J On 2024/10/4 21:02:20
It was a few years ago I did this, but I took the series of photos that may assist. I cannot remember if the spring was loaded under tension or not. I am sorry, but the assembly I believe does require the alignment of the end spring hook to align with the rods drill hole to enable the cotter pin to be inserted. Bob J.
Attach file:
Accelerator Linkage 1.JPG (629.11 KB)
Accelerator Linkage 2.JPG (496.16 KB)
Accelerator Linkage 3.JPG (413.73 KB)
Accelerator Linkage 4.JPG (234.15 KB)
Accelerator Linkage 6.JPG (264.03 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=277267