Re: Rear axle seals and bearings
Posted by Pgh Ultramatic On 2024/11/14 0:00:04
Check the manual for the specified end play.packardinfo.com/xoops/html/modules/archi ... tent.php?op=&catID=10&ContentID=383
In this case, it is 4 to 7 thou which is the same thru 55.
Tap the axle in with a hammer to make sure the opposite side bearing is seated, then pull it firmly, to check the end play.
The end play is easily read with an indicator as shown. If it is off, then add or subtract shims as needed.
Attach file:
20241103_155114.jpg (934.53 KB)
In this case, it is 4 to 7 thou which is the same thru 55.
Tap the axle in with a hammer to make sure the opposite side bearing is seated, then pull it firmly, to check the end play.
The end play is easily read with an indicator as shown. If it is off, then add or subtract shims as needed.
Attach file:
20241103_155114.jpg (934.53 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=278905