Re: 282 waterpump
Posted by Bill Bow On 2025/3/16 8:22:35
Thanks TX. I have finally done some "figuring out".
It's picture time. I've used the water pump back plate to attempt to understand what I'm working with.
The engine I removed was a '38 or newer with a '37 water pump buggered on to it. The 2 arrows point to the difference in mounting. The bolt that went into the bottom hole held the pump in place without going through a hole in the water pump housing.
The block that is going in is a '37 or older block. The plate lines up now but there is an additional hole. Does anybody know what the purpose of the hole is?
It's picture time. I've used the water pump back plate to attempt to understand what I'm working with.
The engine I removed was a '38 or newer with a '37 water pump buggered on to it. The 2 arrows point to the difference in mounting. The bolt that went into the bottom hole held the pump in place without going through a hole in the water pump housing.
The block that is going in is a '37 or older block. The plate lines up now but there is an additional hole. Does anybody know what the purpose of the hole is?
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=283431