Re: Electromatic clutch operation
Posted by HH56 On 2009/8/4 19:52:03
missing page. Maybe Kev can insert it in the proper place.
Here is a scan of the schematic with a bit better resolution. It is possible the light was "fooled" by feedback through the relay although I would have thought it might have been a bit dimmer at the point that happened. Most likely circuit, assuming the relays are OK, is thru the L&R coil and EC coil. Ground would be through the closed acc switch and normally closed governor EC contacts. The direct switch is also a possibility if defective. To prove it, disconnect the wires on EC and see if it still lights at neutral. If it does, then there are several possibilites but would involve one of the relay contacts being closed.
Attach file:
Size: 448.57 KB; Hits: 83
(66.74 KB)
Here is a scan of the schematic with a bit better resolution. It is possible the light was "fooled" by feedback through the relay although I would have thought it might have been a bit dimmer at the point that happened. Most likely circuit, assuming the relays are OK, is thru the L&R coil and EC coil. Ground would be through the closed acc switch and normally closed governor EC contacts. The direct switch is also a possibility if defective. To prove it, disconnect the wires on EC and see if it still lights at neutral. If it does, then there are several possibilites but would involve one of the relay contacts being closed.
Attach file:
Size: 448.57 KB; Hits: 83 (66.74 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=34172