Re: Stabilizer for clutch chatter

Posted by flackmaster On 2010/4/19 21:29:13

If someone could please refer to me a machine shop, I have located a useable new production part, however the end coming out of the short ball joint is the wrong thread - IIRC needs to be 3/8 course for the transmission, and the current part is 7/16 fine. There appears to be enough stock to cut down to 3/8, but I have been unsuccessful in finding someone to do it, as it is a right angle to the stem. Help me find the shop and Mal gets the first one....the other alternative is to go to the right angle clipper/donut version, but use of non-factory spec parts may void our warranties...