Re: Headlight switch removal
Posted by Tim Cole On 2011/2/16 20:57:24
What I'm calling set screw is the piece that the shaft goes through on the dashboard. I'll call it the base. Notice the two notches in this piece. These facilitate unscrewing the base from the dashboard so as to allow removal of the switch from the other side. The base screws into the switch though the dashboard.
If you make a spanner you can unscrew the base without making it look like garbage.
Good luck
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=70953