Re: Rear Axle Seal 334929
Posted by Owen_Dyneto On 2011/8/3 12:07:56
Dwight, is that an inner our outer seal?
I don't have an interchange, but if you have the old one, just measure the ID, OD and width and consult any of the many seal catalogs that select by dimensions. Timken has a good one (see below). OD of the new seal should be about 0.002-0.003 larger than the housing bore OD or the OD of the seal you removed. If you don't have the old one, you can get the ID by measuring the diameter of the sealing surface on the axle (inner) or of the hub on the brake drum (outer).
Attach file:
Size: 1,652.37 KB; Hits: 48
I don't have an interchange, but if you have the old one, just measure the ID, OD and width and consult any of the many seal catalogs that select by dimensions. Timken has a good one (see below). OD of the new seal should be about 0.002-0.003 larger than the housing bore OD or the OD of the seal you removed. If you don't have the old one, you can get the ID by measuring the diameter of the sealing surface on the axle (inner) or of the hub on the brake drum (outer).
Attach file:
Size: 1,652.37 KB; Hits: 48This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=82980