Re: '41 super 8 stumbles on idle

Posted by Owen_Dyneto On 2012/3/18 20:45:42

Assuming the points are reasonably new, you could just run a point file thru them to take off the "burr" and regap them. Small amounts of metal transfer from one point to the other isn't all that uncommon, there is a rule (though I forget the details) about how to tell if the condensor is either slightly over or under capacity depending on which way the metal transfers. Not that a small amount of metal transfer is necessarily anything that calls for corrective action.

A point file in your traveling tool box is highly recommended,.