Re: R9 Overdrive Solenoid Spacer direction

Posted by Dell On 2012/7/2 21:41:54

Joe; If you look at the adapter (item in your picture) you will see that the two bolt holes and the hole for the solenoid shaft are in a straight line-the male side of the adapter that fits in the od housing is off set-it can go only one way and have the bolt holes line up. It just happens that the small holes are to the rear. If you want to replace the seal C/R 3060 works well, just drive out the old seal and washer-put in the new seal and old washed and stake the washer in. Dell