Re: R9 Overdrive Solenoid Spacer direction

Posted by Ronaldg On 2012/11/6 10:48:10

What I always do is to "fit" the spacer so that it is in correct location and mark the bottom. I use a jumper wire and give the governor a ground. Then you put a jumper wire to the boas of the solenoid. USE RUBBER GLOVES so you don't get shocked. This will push the plunger out and then with the spacer in the right location you can install the solenoid. Needless to say you have to have the wires onteh solonoid to do this.